Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 1UR-FE)

COMPRESSOR (for 1UR-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


E168828
  1. Detach the clamp.

  1. Remove the screw and the cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


E168829E01
  1. Clamp the cooler compressor in a vise.

  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00270  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.



    I104018
  1. Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.



    I104019
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.