DTC 01-DD Master Reset |
DTC 01-E1 Voice Processing Device ON Error |
| DTC Code | DTC Detection Condition | Trouble Area |
| 01-DD*1 | The device that should be the master has been disconnected after engine start. |
|
| 01-E1*2 | The AMP device records that the AMP output does not function even while the source device operates. |

| 1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT |
Refer to Radio Receiver Power Source Circuit (Click here).
| NEXT | |
| 2.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the K4*1 and K22*2 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K4-5 (ATX+) - K4-15 (ATX-)*1 | Always | 60 to 80 Ω |
| K22-9 (TXM+) - K22-10 (TXM-)*2 | Always | 60 to 80 Ω |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 3.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.

Press the preset switch "channel 3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
| Radio receiver assembly | 190 |
| "Bluetooth" handsfree module | 19D |
| Satellite radio tuner*4 | 1F1 |
| Stereo component amplifier assembly*1 | 440 |
| Multi-media interface ECU*3 | 388 |
| Television display assembly*2 | 1B0 |
| NEXT | |
| 4.CHECK COMPONENT WHICH HAS STORED THIS CODE |
Select the component which has stored this code.
| Component | Proceed to |
| Except "Bluetooth" handsfree module and satellite radio tuner | A |
| "Bluetooth" handsfree module (19D)*2 | B |
| Satellite radio tuner (1F1)*1, *2 | |
| "Bluetooth" handsfree module (19D)*3 | C |
| Satellite radio tuner (1F1)*1, *3 |
|
| ||||
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
Disconnect all connectors between the radio receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
|
| ||||
| OK | |
| 6.REPLACE RADIO RECEIVER ASSEMBLY |
for Column Shift Type:
Replace the radio receiver assembly (Click here).
for Floor Shift Type:
Replace the radio receiver assembly (Click here).
|
| ||||
| OK | ||
| ||