Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A204844E03


Text in Illustration 
*1
Resistance
*2
Temperature
*3
Acceptable Range
-
-
  1. Partially immerse the sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approx. 20°C (68°F)
    2.32 to 2.59 kΩ
    Approx. 80°C (176°F)
    0.310 to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.