Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL SENSOR WIRE
  1. Install the sensor clamp with the nut (labeled A).

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

    NOTICE:
    Make sure the clamp's rotation stopper touches the installation position.

  1. Install the sensor clamp with the bolt (labeled B).

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

    NOTICE:
    When installing the clamp, do not twist the wire harness.

  1. Attach the 7 clips (labeled C).

    NOTICE:
    1. When installing the clamps, do not twist the wire harness.
    2. When installing the clamps, securely insert them as shown in the illustration.



  1. Connect the sensor connector (labeled D).

    NOTICE:
    Securely connect the connector.



    C154448E02



2. INSTALL REAR SPEED SENSOR LH


    C154449E03
  1. Install the speed sensor (labeled A) with the nut (labeled B).

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }

  1. Connect the speed sensor connector (labeled C).

    NOTICE:
    Securely connect the connector.



3. INSTALL REAR SPEED SENSOR RH


    C154450E02
  1. Install the speed sensor (labeled A) with the nut (labeled B).

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }

  1. Connect the speed sensor connector (labeled C).

    NOTICE:
    Securely connect the connector.



4. INSTALL REAR WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. CHECK SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).