Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE REAR WHEEL


4. REMOVE REAR SPEED SENSOR LH


    C154449E02
  1. Disconnect the speed sensor connector (labeled A).

  1. Remove the nut (labeled B) and speed sensor (labeled C).



5. REMOVE REAR SPEED SENSOR RH


    C154450E01
  1. Disconnect the speed sensor connector (labeled A).

  1. Remove the nut (labeled B) and speed sensor (labeled C).



6. REMOVE SKID CONTROL SENSOR WIRE
  1. Disconnect the sensor connector (labeled A).

  1. Detach the 7 clips (labeled B).

  1. Remove the bolt (labeled C).



  1. Remove the nut (labeled D) and skid control sensor wire.


    C154448E01