Home › BRAKE › PARKING BRAKE › PARKING BRAKE PEDAL

PARKING BRAKE PEDAL > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. RELEASE PARKING BRAKE PEDAL


4. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B226740
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    C154230
  1. Remove the lock nut and adjustment nut.



    C154232
  1. Remove the clip.



    C155437
  1. Using a screwdriver, slowly bend up the claw.

    NOTICE:
    Be careful not to damage the No. 1 parking brake cable or claw.

  1. Disconnect the parking brake cable from the parking brake control pedal.



8. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    C154233
  1. Disconnect the connector.

  1. Detach the wire harness clamp from the control pedal.



    C154234
  1. Remove the 3 nuts and parking brake control pedal from the body.