Home › BRAKE › PARKING BRAKE › PARKING BRAKE ASSEMBLY

PARKING BRAKE ASSEMBLY > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL LH


2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C158344
  1. Remove the 2 bolts and disconnect the rear disc brake cylinder.

    NOTICE:
    1. Do not disconnect the flexible hose from the disc brake cylinder.
    2. Do not twist or bend the flexible hose.

  1. Hang the disc brake cylinder with a piece of wire.



3. REMOVE REAR DISC


    C155452E01
  1. Put matchmarks on the rear disc and axle hub if planning to reuse the disc.



    C155453
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.



4. REMOVE PARKING BRAKE SHOE RETURN SPRING


    C179358E01
  1. Using SST, remove the return spring.

    SST
    09703-30011  



5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    C155124E01
  1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

    SST
    09718-00011  

  1. Disconnect the tension spring.

  1. Remove the No. 1 parking brake shoe and shoe adjuster screw set.



6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    C154249E01
  1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

    SST
    09718-00011  

  1. Remove the No. 2 parking brake shoe.



7. REMOVE PARKING BRAKE SHOE LEVER LH


    C155125
  1. Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

  1. Remove the parking brake shoe lever.



8. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C154244
  1. Disconnect the bolt and No. 3 parking brake cable.



9. REMOVE PARKING BRAKE ANCHOR BLOCK


    C155126
  1. Remove the 2 nuts and anchor block.