Home › STEERING › POWER STEERING › POWER STEERING SYSTEM (for 1UR-FE)

POWER STEERING SYSTEM (for 1UR-FE) > SYSTEM DESCRIPTION

for Preparation Click here



DESCRIPTION
  1. In the Variable Flow Control (VFC) power steering system, the power steering ECU receives the steering angle signal, steering zero point memory, vehicle speed signal and engine speed signal through the CAN communication system. The power steering ECU also controls the power steering solenoid valve mounted on the vane pump assembly in accordance with whether the vehicle is driving straight or turning in order to supply an appropriate power steering fluid volume.
    Furthermore, without regard to whether or not the vehicle is being turned, if the power steering ECU cannot receive the steering angle signal, steering zero point memory, vehicle speed signal or engine speed signal, the power steering warning light in the combination meter illuminates and the vehicle enters fail-safe mode.


FUNCTION OF MAIN COMPONENTS

Item
Function
Power steering warning light
Illuminates to inform the driver that a malfunction in the power steering system has occurred.
Power steering solenoid valve
Controls the power steering fluid volume according to the control signals from the power steering ECU.
Steering angle sensor
Transmits the steering angle signal and steering zero point memory to the power steering ECU via CAN communication.
Power steering ECU
  1. Processes the signals sent from the skid control ECU, steering angle sensor and ECM, and controls the power steering solenoid valve.
  2. Controls the system in order to reduce assist force and preserve steering feel. When towing a trailer, the load on the front axle of the vehicle becomes lighter, and therefore, the steering effort required by the driver decreases.
Skid control ECU
Transmits the vehicle speed signal to the power steering ECU via CAN communication.
ECM
Transmits the engine speed signal to the power steering ECU via CAN communication.
Transmission control switch*1 or TOW/HAUL pattern select switch*2
Changes the system to and from towing mode when operated.
  1. *1: for Column Shift Type
  2. *2: for Floor Shift Type