Home › BRAKE › BRAKE › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR BRAKE FLEXIBLE HOSE


    C155439
  1. Install the flexible hose and a new gasket to the disc brake cylinder with the new union bolt.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    HINT:
    Install the flexible hose lock securely in the lock hole in the cylinder.

  1. Set the flexible hose to the connecting point with the brake tube, and then attach a new clip.



    C208569
  1. Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
    3. Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED BRAKE LINE
  1. Bleed brake line

    1. Remove the brake master cylinder reservoir filler cap assembly.

    2. Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.

      Brake fluid:
      SAE J1703 or FMVSS No. 116 DOT3

    3. Connect a vinyl tube to the bleeder plug of the front disc brake cylinder RH.

    4. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1

    5. When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2

    6. Repeat *1 and *2 until all the air in the brake fluid is completely bled out and the new brake fluid comes out.

    7. Tighten the bleeder plug completely.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    8. Replace the brake fluid from the front disc brake cylinder LH using the same procedure as for RH.

    9. Connect a vinyl tube to the bleeder plug of the rear disc brake cylinder RH.

    10. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1

    11. When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2

    12. Repeat *1 and *2 until all the air in the brake fluid is completely bled out and the new brake fluid comes out.

    13. Tighten the bleeder plug completely.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    14. Replace the brake fluid from the rear disc brake cylinder LH using the same procedure as for RH.

  1. Check and bleed brake system.

    1. If the following malfunction symptoms occur, air may have entered the brake fluid line. Perform the following air bleed procedures.

      1. Low pedal or spongy pedal.
      2. Brake pedal is depressed firmly but braking is insufficient.

  1. Check and adjust brake fluid level in reservoir .



3. INSTALL REAR WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }