FRONT AXLE HUB > ON-VEHICLE INSPECTION |
| 1. REMOVE FRONT WHEEL |
| 2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH |
![]() |
Remove the 2 bolts and disc brake caliper from the knuckle.
| 3. REMOVE FRONT DISC |
![]() |
Put matchmarks on the front disc and axle hub if planning to reuse the disc.
Remove the front disc.
| 4. REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD) |
![]() |
Using a screwdriver and hammer, remove the axle hub grease cap.
| 5. INSPECT FRONT AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, measure the looseness near the center of the axle hub.
| 6. INSPECT FRONT AXLE HUB RUNOUT |
![]() |
Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.
| 7. INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD) |
Install the axle hub grease cap.
| 8. INSTALL FRONT DISC |
![]() |
Align the matchmarks, and then install the front disc.
| 9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH |
![]() |
Install the disc brake caliper with 2 new bolts.
| 10. INSTALL FRONT WHEEL |