Home › BRAKE › BRAKE › BRAKE BOOSTER

BRAKE BOOSTER > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. then remove the brake master cylinder sub-assembly from the brake booster assembly.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Remove the brake master cylinder (Click here).



5. DISCONNECT VACUUM HOSE ASSEMBLY
  1. Slide the clip and disconnect the vacuum hose from the check valve.



6. DISCONNECT BRAKE BOOSTER CONNECTOR
  1. Disconnect the 2 brake booster connectors from the brake booster.



7. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate.



8. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)


B165841
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate.



9. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B226740
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



11. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



12. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin.



13. REMOVE BRAKE BOOSTER ASSEMBLY


    C208550
  1. Remove the 4 nuts, and then pull out the brake booster.

  1. Remove the brake booster gasket from the brake booster.

  1. Loosen the lock nut and then remove the clevis.



14. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY