SHIFT LEVER ASSEMBLY (for Column Shift Type) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate.
| 3. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate.
| 4. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 9 clips and claw.
![]() |
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 7. REMOVE STEERING PAD (w/o Steering Pad Switch) |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.
Disconnect the 2 connectors and remove the steering pad.
| 8. REMOVE STEERING PAD (w/ Steering Pad Switch) |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.
Disconnect the 2 connectors and remove the steering pad.
| 9. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel set nut.
![]() |
Put matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel.
| 10. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
| 11. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 12. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Disconnect the 5 connectors from the combination switch with spiral cable.
![]() |
Using pliers, grip the claws of the clamp and remove the combination switch with spiral cable from the steering column.
| 13. REMOVE COLUMN SHIFT ASSEMBLY |
Move the shift lever to N.
![]() |
Disconnect the column shift transmission control cable end from the column shift.
![]() |
Disconnect the connector and detach the harness clamp.
Using a T30 "TORX" wrench, remove the 3 bolts and column shift.