Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



SKID CONTROL ECU

C240418E04


Terminal No. (Symbols)
Terminal Description
A17-16 (GND1)
Skid control ECU ground
A17-15 (STPO)
Stop light control relay (BRK NO. 1) signal input
A17-14 (PKB2)
Parking brake switch signal input
A17-13 (CANL)
Vehicle CAN communication line
A17-12 (CANH)
Vehicle CAN communication line
A17-11 (EXI2)
A.D.D. detection switch signal input (4WD)
A17-10 (D/G)
Diagnosis tester communication line
A17-9
No pin
A17-8 (IG1)
IG1 power supply
A17-7 (TS)
Sensor check input
A17-6 (STP2)
Stop light switch signal input
A17-5
No pin
A17-4 (CSW)
VSC OFF switch signal input
A17-3 (SP1)
Vehicle speed pulse signal output
A17-2
No pin
A17-1 (+BM)
Motor relay power supply
A17-31 (BST)
Brake booster solenoid ground
A17-30 (PIM)
Pedal stroke sensor (Delta S sensor) input line
A17-29 (GYAW)
Yaw rate sensor ground
A17-28
No pin
A17-27 (E3)
Pedal stroke sensor (Delta S sensor) ground
A17-26 (VCP)
Pedal stroke sensor (Delta S sensor) power source
A17-25
No pin
A17-24 (PSNC)
Brake booster micro switch (Normal Close) signal input
A17-23 (PSNO)
Brake booster micro switch (Normal Open) signal input
A17-22 (VYS)
Yaw rate sensor power source
A17-21 (STS)
Brake booster micro switch power source
A17-20
No pin
A17-19 (SS2)
Yaw rate sensor signal line
A17-18 (SS1)
Yaw rate sensor signal line
A17-17 (BSTP)
Brake booster solenoid power source
A17-47
No pin
A17-46 (FL-)
Front wheel LH speed signal line
A17-45 (FL+)
Front wheel LH speed signal line
A17-44 (BSW)
Stop light control relay (BRK NO. 2) drive input
A17-43 (RR+)
Rear wheel RH speed signal line
A17-42 (RR-)
Rear wheel RH speed signal line
A17-41
No pin
A17-40
No pin
A17-39
No pin
A17-38 (STP)
Stop light switch signal input
A17-37 (RL-)
Rear wheel LH speed signal line
A17-36 (RL+)
Rear wheel LH speed signal line
A17-35
No pin
A17-34 (FR+)
Front wheel RH speed signal line
A17-33 (FR-)
Front wheel RH speed signal line
A17-32 (+BS)
Solenoid relay power supply

CHECK SKID CONTROL ECU

C240419E03

  1. Disconnect the A17 ECU connector.

  2. Measure the voltage or resistance according to the value(s) in the table below.

    HINT:
    Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.


    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A17-16 (GND1) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    A17-15 (STPO) - Body ground
    BR - Body ground
    Stop light control relay (BRK NO. 1) signal input
    Ignition switch ON
    11 to 14 V
    A17-14 (PKB2) - Body ground
    LG - Body ground
    Parking brake switch signal input
    Parking brake switch ON
    Below 1 Ω
    A17-11 (EXI2) - Body ground
    GR - Body ground
    A.D.D. detection switch signal input (4WD)
    A.D.D. detection switch ON
    Below 1 Ω
    A17-10 (D/G) - J17-7 (SIL)
    P - BE
    Diagnosis tester communication line
    Always
    Below 1 Ω
    A17-8 (IG1) - Body ground
    V - Body ground
    IG1 power supply
    Ignition switch ON
    11 to 14 V
    A17-7 (TS) - J17-12 (TS)
    W - G
    Sensor check input
    Always
    Below 1 Ω
    A17-6 (STP2) - Body ground
    GR - Body ground
    Stop light switch signal input
    Brake pedal depressed
    8 to 14 V
    Brake pedal released
    Below 1.5 V
    A17-4 (CSW) - Body ground
    P - Body ground
    VSC OFF switch signal input
    VSC OFF switch ON
    Below 1 Ω
    A17-3 (SP1) - Body ground
    Y - Body ground
    Vehicle speed pulse signal output
    Always
    11 to 14 V
    A17-1 (+BM) - Body ground
    L - Body ground
    Motor relay power supply
    Always
    11 to 14 V
    A17-31 (BST) - A17-17 (BSTP)
    B - V
    Brake booster solenoid ground
    Always
    1 to 2 Ω
    A17-30 (PIM) - A17-27 (E3)
    R - BE
    Pedal stroke sensor (Delta S sensor) input line
    Always
    4 to 8 kΩ
    for 4WD:
    1. A17-29 (GYAW) - P16-5 (GYAW)
    P - G
    Yaw rate sensor ground
    Always
    Below 1 Ω
    for 2WD:
    1. A17-29 (GYAW) - P15-5 (GYAW)
    A17-27 (E3) - Body ground
    BE - Body ground
    Pedal stroke sensor (Delta S sensor) ground
    Always
    10 kΩ or higher
    A17-26 (VCP) - A17-27 (E3)
    G - BE
    Pedal stroke sensor (Delta S sensor) power source
    Always
    150 to 200 Ω
    A17-24 (PSNC) - A17-21 (STS)
    L - SB
    Brake booster micro switch (Normal Close) signal input
    Always
    Below 1 Ω
    A17-23 (PSNO) - A17-21 (STS)
    LG - SB
    Brake booster micro switch (Normal Open) signal input
    Brake pedal depressed
    Below 1 Ω
    for 4WD:
    1. A17-22 (VYS) - P16-3 (VYS)
    R - R
    Yaw rate sensor power source
    Always
    Below 1 Ω
    for 2WD:
    1. A17-22 (VYS) - P15-3 (VYS)
    A17-21 (STS) - A17-24 (PSNC)
    SB - L
    Brake booster micro switch power source
    Always
    Below 1 Ω
    for 4WD:
    1. A17-19 (SS2) - P16-1 (YAW2)
    W - W
    Yaw rate sensor signal line
    Always
    Below 1 Ω
    for 2WD:
    1. A17-19 (SS2) - P15-1 (YAW2)
    for 4WD:
    1. A17-18 (SS1) - P16-2 (YAW1)
    B - B
    Yaw rate sensor signal line
    Always
    Below 1 Ω
    for 2WD:
    1. A17-18 (SS1) - P15-2 (YAW1)
    A17-17 (BSTP) - A17-31 (BST)
    V - B
    Brake booster solenoid power source
    Always
    1 to 2 Ω
    A17-46 (FL-) - b2-1
    LG - B
    Front wheel LH speed signal line
    Always
    Below 1 Ω
    A17-45 (FL+) - b2-2
    V - W
    Front wheel LH speed signal line
    Always
    Below 1 Ω
    A17-44 (BSW) - Body ground
    L - Body ground
    Stop light control relay (BRK NO. 2) drive input
    Ignition switch ON
    11 to 14 V
    A17-43 (RR+) - b3-2
    B - W
    Rear wheel RH speed signal line
    Always
    Below 1 Ω
    A17-42 (RR-) - b3-1
    W - B
    Rear wheel RH speed signal line
    Always
    Below 1 Ω
    A17-38 (STP) - Body ground
    Y - Body ground
    Stop light switch signal input
    Brake pedal depressed
    8 to 14 V
    Brake pedal released
    Below 1.5 V
    A17-37 (RL-) - b4-1
    P - B
    Rear wheel LH speed signal line
    Always
    Below 1 Ω
    A17-36 (RL+) - b4-2
    L - W
    Rear wheel LH speed signal line
    Always
    Below 1 Ω
    A17-34 (FR+) - b1-2
    BE - W
    Front wheel RH speed signal line
    Always
    Below 1 Ω
    A17-33 (FR-) - b1-1
    G - B
    Front wheel RH speed signal line
    Always
    Below 1 Ω
    A17-32 (+BS) - Body ground
    R - Body ground
    Solenoid relay power supply
    Always
    11 to 14 V