GENERATOR > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY CAP |
![]() |
Using a screwdriver, remove the generator pulley cap.
| 2. REMOVE GENERATOR WITH CLUTCH PULLEY |
Mount the generator in a vise between aluminum plates.
![]() |
Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.
| *1 | Rotor Shaft |
![]() |
Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
| *a | Hold |
![]() | Turn |
Remove SST from the generator.
Remove the generator with clutch pulley from the rotor shaft.
| 3. REMOVE GENERATOR REAR END COVER |
![]() |
Remove the nut and cord clip.
![]() |
Remove the 3 nuts and generator rear end cover.
| 4. REMOVE TERMINAL INSULATOR |
![]() |
Remove the terminal insulator from the generator coil.
| 5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and brush holder from the generator coil.
| 6. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts.
![]() |
Using SST, remove the generator coil assembly.
| *a | Hold |
![]() | Turn |
| 7. REMOVE GENERATOR ROTOR ASSEMBLY |
![]() |
Remove the generator washer.
![]() |
Remove the generator rotor assembly.
| 8. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the drive end frame bearing is not rough or worn.
If necessary, replace the generator drive end frame bearing.
| 9. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Remove the 4 screws and retainer plate from the drive end frame.
![]() |
Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.