Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2793    Transponder Chip Malfunction

DTC    B2794    Unmatched Encryption Code

DTC    B2795    Unmatched Key Code

for Preparation Click here


DESCRIPTION

  1. B2793 is output when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if the key code registration cannot be performed normally and this DTC is detected.
  2. B2794 is output when a key with an incomplete key code is inserted into the ignition key cylinder.
  3. B2795 is output when a key with a key code that has not been registered in the ECU is inserted into the ignition key cylinder.

DTC Code
DTC Detection Condition
Trouble Area
B2793
Transponder chip malfunction
Key
B2794
Key with incomplete key code is inserted
B2795
Key with unregistered key code is inserted

INSPECTION PROCEDURE

1.REREGISTER KEY
  1. Clear the DTCs (Click here).

  1. Reregister the key code with the transponder key ECU .

  1. Check that the engine starts with the key.

    OK:
    Engine starts.



NG
REPLACE KEY
OK

END