Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU.
This DTC is output when there is an open or short malfunction in the antenna coil.

DTC Code
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Harness or connector
  2. Transponder key ECU
  3. Transponder key amplifier

WIRING DIAGRAM


B121682E15


INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID .

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B2784 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.READ VALUE USING TECHSTREAM (ANTENNA COIL)
  1. Use the Data List to check if the transponder key coil is functioning properly.

    Immobiliser 
    Tester Display
    Measurement Item/Display
    Normal Condition
    Diagnostic Note
    Antenna Coil
    Antenna coil condition / Normal or Fail
    Normal: Antenna coil is normal
    Fail: Antenna coil is malfunctioning
    -

    OK:
    Normal (Antenna coil is normal) appears on the screen.



NG
Go to step 4
OK

REPLACE TRANSPONDER KEY ECU (Click here)  

4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
B110403E28
  1. Disconnect the J26 ECU connector.

  1. Disconnect the J20 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J26-14 (VC5) - J20-1 (VC5)
    Always
    Below 1 Ω
    J26-15 (CODE) - J20-4 (CODE)
    J26-4 (TXCT) - J20-5 (TXCT)
    J26-5 (AGND) - J20-7 (AGND)
    J26-14 (VC5) or J20-1 (VC5) - Body ground
    Always
    10 kΩ or higher
    J26-15 (CODE) or J20-4 (CODE) - Body ground
    J26-4 (TXCT) or J20-5 (TXCT) - Body ground
    J26-5 (AGND) or J20-7 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B2784 is not output.



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)