Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


C155989
  1. Remove the bolt, nut and stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



3. DISCONNECT FRONT SHOCK ABSORBER WITH COIL SPRING LH


C155964
  1. Remove the nut and bolt, and disconnect the shock absorber from the lower side.



4. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH


C155985
  1. Remove the 2 bolts and disconnect the attachment from the steering knuckle.



5. REMOVE FRONT NO. 1 SUSPENSION ARM SUB-ASSEMBLY LOWER LH


C155986E01
  1. Place matchmarks on the No. 2 camber adjusting cam and No. 2 toe adjusting plate.

  1. Remove the nut, washer, No. 2 camber adjusting cam, camber adjusting cam assembly, bolt, toe adjusting cam, No. 2 toe adjusting plate and front No. 1 suspension arm lower LH.



6. REMOVE FRONT LOWER BALL JOINT ATTACHMENT LH
  1. Remove the cotter pin and nut.



    C181302E01
  1. Using SST, remove the lower ball joint attachment.

    SST
    09950-40011   (09951-04010, 09953-04020, 09954-04010, 09955-04031, 09958-04011, 09952-04010)
    09955-04090  

    HINT:
    Claw A 09955-04090
    Claw B 09955-04031