Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Stereo Component Tuner Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

The stereo component tuner assembly sends sound signals to the television display assembly through this circuit. If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly or speakers.

WIRING DIAGRAM


E190585E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - TELEVISION DISPLAY)


    E191666E01
  1. Disconnect the K29 stereo component tuner assembly connector.

  1. Disconnect the W2 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K29-10 (FRI+) - W2-28 (R+)
    Always
    Below 1 Ω
    K29-9 (FRI-) - W2-29 (R-)
    Always
    Below 1 Ω
    K29-8 (FLI+) - W2-30 (L+)
    Always
    Below 1 Ω
    K29-7 (FLI-) - W2-31 (L-)
    Always
    Below 1 Ω
    K29-10 (FRI+) - Body ground
    Always
    10 kΩ or higher
    K29-9 (FRI-) - Body ground
    Always
    10 kΩ or higher
    K29-8 (FLI+) - Body ground
    Always
    10 kΩ or higher
    K29-7 (FLI-) - Body ground
    Always
    10 kΩ or higher
    W2-27 (SLD9) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)