Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Navigation Voice Circuit

for Preparation Click here


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on.

WIRING DIAGRAM


E190587E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER)


    E191670E01
  1. Disconnect the K21 navigation receiver assembly connector.

  1. Disconnect the K15 stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    K21-11 (IVO+) - K15-23 (II1+)
    Always
    Below 1 Ω
    K21-12 (IVO-) - K15-22 (II1-)
    Always
    Below 1 Ω
    K21-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    K21-12 (IVO-) - Body ground
    Always
    10 kΩ or higher
    K21-13 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)