Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AXLE SHAFT SNAP RING


    C159455
  1. Using a snap ring expander, remove the snap ring.



2. REMOVE REAR AXLE SHAFT


    C159456E01
  1. Using SST and a press, press out the rear axle shaft.

    SST
    09521-25011  
    09521-60010  

  1. Remove the rear axle bearing inner retainer from the axle hub.

  1. Remove the rear axle shaft washer from the axle hub.



    F042797
  1. Grind the rear axle bearing inner race surface using a grinder, then remove it with a chisel.



3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C159457
  1. Temporarily install 4 nuts to the housing bolts.

    NOTICE:
    Do not use any nuts removed from the vehicle, as they may be damaged.

  1. Using a hammer, remove the 4 housing bolts and rear axle hub and bearing.

  1. Remove the nuts.



4. REMOVE BRAKE DRUM OIL DEFLECTOR


    C159721E01
  1. Using SST, remove the 5 hub bolts.

    SST
    09650-17011  

  1. Remove the deflector and deflector gasket from the rear axle shaft.