Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REASSEMBLY

for Preparation Click here


NOTICE:
Do not allow foreign matter, etc. to contact the ABS rotor bearing.



1. INSTALL BRAKE DRUM OIL DEFLECTOR


    C160259E02
  1. Install a new deflector gasket and deflector to the rear axle shaft.

    HINT:
    Align the 2 oil drain holes.



    C159723
  1. Temporarily install a washer and nut to 5 new hub bolts as shown in the illustration.

  1. Install the hub bolts by tightening each nut.

  1. Removed the washer and nut from each hub bolt.



2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Position the parking brake plate on a new rear axle hub and bearing.

    NOTICE:
    Make sure to securely fit the bearing to the parking brake plate.



    F042777
  1. Using 2 socket wrenches and a press, press in the 4 housing bolts.



3. INSTALL REAR AXLE SHAFT


    G022121E01
  1. Install the washer and a new retainer to the axle hub as shown in the illustration.

    NOTICE:
    1. Install the washer with its tapered surface facing downward.
    2. Install the retainer with its chamfered surface facing downward.

  1. Using SST and a press, press in the rear axle shaft.

    SST
    09631-12090  
    09726-40010  
    09951-01100  

    NOTICE:
    Make sure to securely fit the bearing to the rear axle shaft.



4. INSTALL REAR AXLE SHAFT SNAP RING


    C159455
  1. Using a snap ring expander, install a new snap ring.