Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.



2. REMOVE ECM


    A124571E03
  1. Raise the 2 levers while pushing the locks on the 2 levers.
    Text in Illustration 
    *a
    Push
    *b
    Lock

    NOTICE:
    A155994
    Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.

  1. Disconnect the 2 connectors.



    A155993
  1. Remove the 4 bolts and ECM.



3. REMOVE ECM GASKET


    A198571
  1. Peel off the rubber part of the gasket.



    A198572E02
  1. Spray gasket remover or equivalent on the remaining tape of the gasket.
    Text in Illustration 
    *1
    Cloth

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connector with a cloth.



    A198573
  1. Remove the tape of the gasket without using bladed objects.