Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
  1. Avoid physical shocks to the accelerator pedal rod assembly.
  2. Do not disassemble the accelerator pedal rod assembly.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal rod assembly.
    If applied, the accelerator pedal rod assembly must be replaced.

  1. Install the accelerator pedal rod with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the accelerator pedal position sensor connector.