DTC C1251/51 Open in Pump Motor Circuit |
DTC C0273/13 Open in ABS Motor Relay Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1251/51 | When any of following conditions detected with normal battery voltage (10 V or more):
|
|
| C0273/13 | When one of following conditions is met:
|
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (MOTOR RELAY) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTC (Click here).
Select the Active Test mode on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | Motor relay | ON / OFF | Operation sound of motor can be heard |
Check the operation sound of the motor when operating it with the Techstream.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT FUSE (ABS1) |
![]() |
Remove the ABS1 H-fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ABS1 H-fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A17 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-1 (+BM) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-16 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||