Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER SHAFT ASSEMBLY (for 2 Joint Type)


C158582E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 bolts and 4 nuts. Then disconnect the propeller shaft from the differential side.

  1. Remove the propeller shaft.



    C164127E05
  1. Insert SST into the transmission to prevent oil leakage.

    SST
    09325-40010  



2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 3 Joint Type)


    C158582E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 bolts and 4 nuts. Then disconnect the propeller shaft from the differential side.



    C158583
  1. w/o Bearing Washer:
    Remove the 2 mounting bolts from the crossmember.

  1. w/ Bearing Washer:
    Remove the 2 mounting bolts and 2 bearing washers from the crossmember.

  1. Remove the propeller shaft.



    C164127E04
  1. for A750E and A760E:
    Insert SST into the transmission to prevent oil leakage.

    SST
    09325-40010  



    C160071E01
  1. for AB60E:
    Insert SST into the transmission to prevent oil leakage.

    SST
    09325-60010