THERMOSTAT > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 4. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disconnect the MAF meter connector and clamp.
Disconnect the ventilation hose and vacuum hose.
Loosen the hose clamp.
Remove the 2 bolts and air cleaner.
| 5. REMOVE AIR TUBE SUB-ASSEMBLY LH |
![]() |
Disconnect the 2 connectors.
Disconnect the water by-pass hose.
![]() |
Disconnect the 2 wire harness clamps and air hose.
Remove the bolt and disconnect the air tube LH from the water inlet housing.
![]() |
Disconnect the vacuum sensor connector and clamp.
Remove the 2 bolts and disconnect the air hose from the air switching valve LH.
Remove the air tube LH.
| 6. DISCONNECT OUTLET RADIATOR HOSE |
![]() |
Disconnect the radiator hose.
| 7. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT |
![]() |
Remove the 3 nuts, water inlet with thermostat and gasket.