THERMOSTAT > INSTALLATION |
| 1. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT |
![]() |
Install a new gasket and the water inlet with thermostat with the 3 nuts.
| 2. CONNECT OUTLET RADIATOR HOSE |
![]() |
Connect the radiator hose.
| 3. INSTALL AIR TUBE SUB-ASSEMBLY LH |
![]() |
Connect the air hose to the air switching valve LH, and install the air tube LH with the 2 bolts.
Connect the vacuum sensor connector and clamp.
![]() |
Connect the air tube LH to the water inlet housing with the bolt.
Connect the air hose.
Connect the 2 wire harness clamps.
![]() |
Connect the water by-pass hose and 2 connectors.
| 4. ADD ENGINE COOLANT |
Add engine coolant.
| Item | Specified Condition |
| w/ Trailer Towing System | 13.2 liters (13.9 US qts, 11.6 Imp. qts) |
| w/o Trailer Towing System | 12.1 liters (12.8 US qts, 10.6 Imp. qts) |
![]() |
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Press the inlet and outlet radiator hoses several times by hand, and then check the coolant level. If the coolant level is low, add coolant.
Install the radiator cap.
Start the engine and warm it up until the thermostat opens.
Maintain the engine speed at 2000 to 2500 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down to ambient temperature.
![]() |
Check that the coolant level is between the FULL and LOW lines.
If the coolant level is below the LOW line, repeat all of the procedures above.
If the coolant level is above the FULL line, drain coolant so that the coolant level is between the FULL and LOW lines.
| 5. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 6. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Install the air cleaner with the 2 bolts.
Tighten the hose clamp.
Connect the ventilation hose and vacuum hose.
Connect the MAF meter connector and clamp.
| 7. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.
| 8. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Hook the engine under cover to the vehicle body as shown in the illustration.
Install the 3 screws and 5 bolts.