RADIATOR > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

| *1 | Radiator Reservoir | *2 | Radiator Cap |
| *3 | Radiator Drain Cook Plug | *4 | Cylinder Block Drain Cock Plug |
Remove the radiator cap. Then drain the coolant.
Tighten the 2 cylinder block drain cock plugs.
Tighten the radiator drain cock plug by hand.
| 3. REMOVE RADIATOR HOSE INLET |
![]() |
| 4. REMOVE RADIATOR HOSE OUTLET |
![]() |
Disconnect the radiator hose outlet from the water inlet.
![]() |
Remove the radiator hose outlet.
| 5. REMOVE FAN SHROUD |
![]() |
Loosen the 4 nuts holding the fluid coupling fan.
Remove the fan and generator V-belt (Click here).
![]() |
Disconnect the reservoir hose from the radiator tank upper.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the water pump.
| 6. REMOVE RADIATOR ASSEMBLY |
![]() |
Using a clip remover, remove the 3 clips and disconnect the radiator side deflector RH.
![]() |
Using a clip remover, remove the 3 clips and disconnect the radiator side deflector LH.
![]() |
Remove the 4 bolts and radiator.