Home › TRANSMISSION · AB60E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


C160109E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1. 2 (RB) - 6 (PL)
    2. 4 (B) - 5 (L)
    Shift lever position on P
    Below 1 Ω
    2 (RB) - 1 (RL)
    Shift lever position on R
    Below 1 Ω
    1. 2 (RB) - 9 (NL)
    2. 4 (B) - 5 (L)
    Shift lever position on N
    Below 1 Ω
    2 (RB) - 7 (DL)
    1. Shift lever position on D
    2. Shift lever position on S, "+" or "-"
    Below 1 Ω
    1. 2 (RB) - 6 (PL)
    2. 4 (B) - 5 (L)
    Shift lever position not on P
    10 kΩ or higher
    2 (RB) - 1 (RL)
    Shift lever position not on R
    10 kΩ or higher
    1. 2 (RB) - 9 (NL)
    2. 4 (B) - 5 (L)
    Shift lever position not on N
    10 kΩ or higher
    2 (RB) - 7 (DL)
    1. Shift lever position not on D
    2. Shift lever position not on S, "+" or "-"
    10 kΩ or higher

    If the result is not as specified, replace the park/neutral position switch assembly.