REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL REAR CRANKSHAFT OIL SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Install the crankshaft angle sensor rotor.
![]() |
Install the drive plate and rear drive plate spacer onto the crankshaft.
![]() |
Apply adhesive to 2 or 3 threads of the 8 bolts.
![]() |
Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.
![]() |
Mark the top of each drive plate installation bolt with paint.
Tighten the drive plate installation bolts 90° as shown in the illustration.
Check that the painted marks are now at a 90° angle to the top.
| 3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |
for 2WD:
Refer to the following procedures (Click here).
for 4WD:
Refer to the following procedures (Click here).
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |