REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
for 2WD:
Refer to the following procedures (Click here).
for 4WD:
Refer to the following procedures (Click here).
| 4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 10 bolts, rear drive plate spacer, drive plate and crankshaft angle sensor rotor.
| 5. REMOVE REAR CRANKSHAFT OIL SEAL |
Using a knife, cut off the lip of the oil seal.
![]() |
Using a screwdriver, pry out the oil seal.