GENERATOR > INSTALLATION |
| 1. INSTALL GENERATOR ASSEMBLY |
![]() |
Install the generator with the 3 bolts and nut.
![]() |
Connect the generator connector.
Connect the generator wire with the nut.
Install the terminal cap.
Install the harness bracket to the generator with the bolt.
| 2. CONNECT VANE PUMP ASSEMBLY |
![]() |
![]() |
Connect the vane pump to the timing chain cover with the 2 bolts.
![]() |
Attach the 2 clamps and connect the power steering oil pressure switch connector.
| 3. INSTALL FRONT FENDER APRON SEAL RH |
Install the apron seal with the 5 clips.
| 4. INSTALL FAN & GENERATOR V BELT |
![]() |
Set the V belt onto every part.
While turning the belt tensioner counterclockwise, remove the pin.
![]() |
After installing the belt, check that it fits properly in the ribbed grooves.
| 5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
![]() |
Hook the engine under cover to the vehicle body as shown in the illustration.
Install the 3 screws and 5 bolts.
| 6. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Install the air cleaner case with the 2 bolts.
Install the air cleaner element onto the air cleaner case.
![]() |
Install the air cleaner cap.
Fasten the 4 hook clamps.
Connect the MAF meter connector.
Attach the wire harness clamp.
| 7. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose with the 2 clamps.
Connect the vacuum hose and ventilation hose.
| 8. INSTALL V-BANK COVER |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |