Home › ENGINE ยท 1UR-FE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here).



4. REMOVE AIR CLEANER ASSEMBLY


    A215422
  1. Disconnect the MAF meter connector and clamp.

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



5. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 6 clips and fender apron seal.



6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C181326
  1. Disconnect the oil pressure sensor connector.



7. DISCONNECT SOLENOID VALVE CONNECTOR


C181333
  1. Disconnect the solenoid valve connector.



8. DISCONNECT VANE PUMP ASSEMBLY


    A163289
  1. Remove the 2 bolts and disconnect the vane pump.



9. DISCONNECT OIL COOLER TUBE SUB-ASSEMBLY (w/ Trailer Towing System)


    A217475
  1. Remove the 2 bolts and disconnect the oil cooler tube.



10. REMOVE GENERATOR ASSEMBLY


    A215539
  1. Remove the terminal cap.

  1. Disconnect the generator connector.

  1. Remove the nut and disconnect the generator wire.

  1. Remove the bolt and disconnect the wire harness bracket from the generator.



    A216790
  1. Remove the 3 bolts, nut and generator.