FRONT UPPER SUSPENSION ARM > INSTALLATION |
| 1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH |
![]() |
Temporarily install the suspension upper arm with the 2 washers, bolt and nut.
| 2. INSTALL FRONT FENDER APRON SEAL REAR LH |
Install the apron seal with the 5 clips.
| 3. INSTALL FRONT FENDER APRON SEAL LH |
Install the apron seal with the 6 clips.
| 4. CONNECT STEERING KNUCKLE LH |
Connect the steering knuckle to the suspension upper arm.
Install the nut and a new cotter pin.
| 5. CONNECT SKID CONTROL SENSOR WIRE |
![]() |
Connect the sensor wire to the steering knuckle and upper arm with the 2 bolts.
| 6. TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING LH |
![]() |
Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.
![]() |
Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.
| 7. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 8. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH |
Tighten the nut.
| 9. TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Tighten the nut.
![]() |
Tighten the 4 upper nuts in diametrically opposite pairs.
Check that the first nut that was tightened is at the torque specification.
| 10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).
| 11. INSTALL FRONT WHEEL |