Home › ENGINE ยท 1UR-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION SWITCH ASSEMBLY


    C155157
  1. Attach the 2 claws to install the ignition switch to the steering lock.



2. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt)
  1. Temporarily install the upper steering column with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C155159
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



3. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
  1. Temporarily install the upper steering column with switch bracket and steering lock bracket with 2 new tapered-head bolts.



    C159755
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



4. INSTALL STEERING COLUMN ASSEMBLY
  1. for Manual Tilt: (Click here)

  1. for Manual Tilt and Manual Telescopic Steering Column: (Click here)



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL