Home › ENGINE · 1GR-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION SWITCH ASSEMBLY


    A161560E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    All terminals
    LOCK
    10 kΩ or higher
    2 (ACC) - 4 (AM1)
    ACC
    Below 1 Ω
    1 (IG1) - 4 (AM1)
    ON
    2 (ACC) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    1 (IG1) - 4 (AM1)
    START
    3 (ST1) - 4 (AM1)
    5 (AM2) - 6 (IG2)
    5 (AM2) - 7 (ST2)

    Text in Illustration 
    *1
    LOCK
    *2
    ACC
    *3
    ON
    *4
    START
    *a
    Component without harness connected
    (Ignition Switch)
    If the result is not as specified, replace the ignition switch assembly.