Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT NO. 1 SPRING BUMPER LH
  1. Install the No. 1 spring bumper to the vehicle.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }



2. INSTALL FRONT NO. 2 LOWER ARM LH


C155983E01
  1. Using SST and a press, press in a new bush.

    SST
    09710-26011   (09710-05081)

    NOTICE:
    Press the bush while making sure the bush positioning protrusions are perpendicular to the lower arm, as shown in the illustration.



3. INSTALL FRONT NO. 1 LOWER ARM BUSH LH


C155984E01
  1. Using SST and a press, press in a new bush.

    SST
    09223-00010  
    09612-30012  



4. INSTALL FRONT LOWER BALL JOINT ATTACHMENT LH
  1. Install the attachment with the nut and a new cotter pin.

    Torque:
    167 N*m{ 1703 kgf*cm , 123 ft.*lbf }

    NOTICE:
    If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.