VANE PUMP (for 1GR-FE) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 4. REMOVE FAN AND GENERATOR V BELT |
![]() |
While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.
Remove the V belt.
| 5. DRAIN POWER STEERING FLUID |
| 6. DISCONNECT SUCTION HOSE |
![]() |
Disconnect the suction hose.
| 7. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR |
![]() |
Disconnect the power steering oil pressure switch connector.
| 8. DISCONNECT PRESSURE FEED TUBE |
![]() |
Remove the union bolt and disconnect the pressure feed tube.
Remove the gasket.
| 9. REMOVE VANE PUMP ASSEMBLY |
Disconnect the wire harness clamp.
![]() |
Remove the 2 bolts and vane pump.