Home › STEERING › POWER STEERING › VANE PUMP (for 1UR-FE)

VANE PUMP (for 1UR-FE) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator assembly (Click here).



4. DRAIN POWER STEERING FLUID


5. SEPARATE HARNESS BRACKET


C181324
  1. Remove the bolt and separate the bracket.



6. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


C181325E01
  1. Detach the clip and disconnect the hose.



7. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C181326
  1. Disconnect the oil pressure sensor connector.



8. DISCONNECT SOLENOID VALVE CONNECTOR


C181333
  1. Disconnect the solenoid valve connector.



9. SEPARATE PRESSURE FEED TUBE


    C181327
  1. Remove the bolt and separate the pressure feed tube.

  1. Remove the gasket.



10. REMOVE VANE PUMP ASSEMBLY


C181328
  1. Remove the 2 bolts and vane pump assembly.