EXHAUST PIPE (for Regular Cab Standard Deck) > INSTALLATION |
| 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 3 new nuts.
| 2. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Install a new gasket and the front No. 2 exhaust pipe to the exhaust manifold LH with 3 new nuts.
| 3. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
Install a new gasket to the front No. 2 exhaust pipe.
Install the front No. 3 exhaust pipe to the exhaust pipe support.
Install the front No. 3 exhaust pipe with the 2 bolts and 2 new nuts.
| 4. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Install the center exhaust pipe to the 3 exhaust pipe supports.
Install 2 new gaskets to the front exhaust pipe LH and RH.
Install the center exhaust pipe with the 4 bolts.
| 5. INSTALL TAILPIPE ASSEMBLY |
Install the tailpipe to the exhaust pipe support.
![]() |
Set a new gasket to the center exhaust pipe.
Connect the tailpipe to the center pipe with a new clamp.
| *a | Upper |
| *b | LH Side |
| *c | Front |
| 6. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, install the sensor.
| *a | Fulcrum Length |
Connect the connector.
| 7. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, install the sensor.
| *a | Fulcrum Length |
Connect the connector.
| 8. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() |
Using SST, install the sensor.
| *a | Fulcrum Length |
Connect the connector and 2 clamps.
| 9. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() |
Using SST, install the sensor.
| *a | Fulcrum Length |
Connect the connector.
| 10. INSPECT FOR EXHAUST GAS LEAK |