PROPELLER SHAFT ASSEMBLY (for 4WD) > REMOVAL |
| 1. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and insulator bracket.
| 2. REMOVE TRANSFER HEAT INSULATOR |
![]() |
Remove the 3 bolts and heat insulator.
| 3. REMOVE PROPELLER SHAFT ASSEMBLY (for 2 Joint Type) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts and 4 bolts, and disconnect the propeller shaft from differential side.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts and propeller shaft.
| 4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 3 Joint Type) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 bolts and 4 nuts.
![]() |
w/o Bearing Washer:
Remove the 2 mounting bolts from the frame crossmember.
w/ Bearing Washer:
Remove the 2 mounting bolts and 2 bearing washers from the frame crossmember.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts and propeller shaft.