Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER SHAFT HEAT INSULATOR


C158452
  1. Remove the 2 bolts and heat insulator from the heat insulator bracket.



2. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
  1. Remove the 2 bolts and heat insulator bracket from the crossmember.



3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C158457E01
  1. for Front Differential Side:

    1. Place matchmarks on the differential and propeller shaft flange.

    2. Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.

      NOTICE:
      Use a rope to suspend the front edge of the propeller shaft.



    C158456E02
  1. for Transfer Side:

    1. Place matchmarks on the transfer and propeller shaft flanges.

    2. Remove the 4 nuts and 4 washers.

  1. Remove the propeller shaft from the transfer flange.