Home › DRIVE LINE › JF1A TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TRANSFER INPUT SHAFT


    C159730
  1. Using a micrometer, measure the diameter of the transfer input shaft journal surface.

    Minimum diameter:
    68.002 mm (2.678 in.)

    If the diameter is less than the minimum, replace the transfer input shaft.



    C159731
  1. Using a dial indicator, measure the inside diameter of the transfer input shaft bush.

    Maximum inside diameter:
    46.034 mm (1.812 in.)

    If the inside diameter is more than the maximum, replace the transfer input shaft.



2. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C159732
  1. Using a feeler gauge, measure the thrust clearance of the pinion gear.

    Standard clearance:
    0.11 to 0.85 mm (0.00434 to 0.0334 in.)

    Maximum clearance:
    0.85 mm (0.0334 in.)

    If the clearance is more than the maximum, replace the transfer low planetary gear assembly.



3. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C159733
  1. Using a dial indicator, measure the radial clearance of the pinion gear.

    Standard clearance:
    0.011 to 0.038 mm (0.000354 to 0.00150 in.)

    Maximum clearance:
    0.038 mm (0.00150 in.)

    If the clearance is more than the maximum, replace the transfer low planetary gear assembly.



4. INSPECT REAR TRANSFER OUTPUT SHAFT


    C159737E01
  1. Using a micrometer, measure the diameter of the rear transfer output shaft journal.

    Minimum diameter:
    Journal
    Specified Condition
    A
    39.986 mm (1.58 in.)
    B
    48.984 mm (1.93 in.)

    If the diameter is less than the minimum, replace the rear transfer output shaft.



5. INSPECT NO. 1 TRANSFER GEAR SHIFT FORK AND FRONT DRIVE CLUTCH SLEEVE


    C159729
  1. Using a feeler gauge, measure the clearance between the front drive clutch sleeve and No. 1 transfer gear shift fork.

    Maximum clearance:
    0.84 mm (0.0331 in.)

    If the clearance is more than the maximum, replace the front drive clutch sleeve or No. 1 transfer gear shift fork.



6. INSPECT NO. 2 TRANSFER GEAR SHIFT FORK AND TRANSFER HIGH AND LOW CLUTCH SLEEVE


    C159728
  1. Using a feeler gauge, measure the clearance between the transfer high and low clutch sleeve and the No. 2 transfer gear shift fork.

    Maximum clearance:
    1.94 mm (0.0763 in.)

    If the clearance is more than the maximum, replace the transfer high and low clutch sleeve or No. 2 transfer gear shift fork.