CANISTER > REMOVAL |
| 1. REMOVE CHARCOAL CANISTER ASSEMBLY |
![]() |
Remove the nut and disconnect the wiring harness clamp bracket.
![]() |
Disconnect the canister pump module connector.
Disconnect the purge line hose.
| *1 | Vent Line Hose |
| *2 | Air Inlet Line Hose |
| *3 | Charcoal Canister Assembly Side |
| *4 | Retainer |
![]() | Upper |
![]() | Pinch |
Disconnect the air inlet line hose.
Push the hose firmly toward the charcoal canister assembly.
Pinch the hose as shown in the illustration.
Pull out the hose.
Disconnect the vent line hose.
Pinch the retainer and raise it.
![]() |
Detach the wire harness clamp.
![]() |
Remove the 4 bolts and charcoal canister assembly.
| 2. REMOVE CHARCOAL CANISTER BASE BRACKET |
![]() |
Disengage the claw and remove the charcoal canister base bracket.
| 3. REMOVE CHARCOAL CANISTER SUPPORT BRACKET |
![]() |
Remove the 2 bolts and charcoal canister support bracket.
| 4. REMOVE CANISTER PUMP MODULE |
Before removing the canister pump module, clean the charcoal canister by blowing air into it to ensure that the charcoal canister is free of foreign matter.
![]() |
While disengaging the 2 claws as shown in the illustration, push the canister pump module upwards using a screwdriver to remove it.
Check if the charcoal canister contains foreign matter such as mud or water.
![]() |
Visually check that the inside of the charcoal canister is free of foreign matter.
Hold the charcoal canister upside down to make sure that the charcoal canister is free of foreign matter.
If the charcoal canister contains foreign matter, replace the charcoal canister.