Home › ENGINE ยท 1UR-FE › IGNITION › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > INSTALLATION

for Preparation Click here



1. INSTALL SPARK PLUG
  1. Using a 16 mm plug wrench, install the 8 spark plugs.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



2. INSTALL IGNITION COIL ASSEMBLY


  1. for Bank 1:



      A215593
    1. Install the 4 ignition coils with the 4 bolts.

      Torque:
      10 N*m{ 102 kgf*cm , 7 ft.*lbf }



    2. A215594
    3. Connect the 4 ignition coil connectors.

    4. Connect the 3 wire harness clamps.



  1. for Bank 2:



      A215597
    1. Install the 4 ignition coils with the 4 bolts.

      Torque:
      10 N*m{ 102 kgf*cm , 7 ft.*lbf }



    2. A215596
    3. Connect the 4 ignition coil connectors and 2 wire harness clamps.



    4. A216323
    5. Connect the water by-pass pipe with the 2 bolts.

      Torque:
      18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    6. A215595
    7. Connect the engine wire harness clamp.



3. INSTALL AIR CLEANER ASSEMBLY


    A215422
  1. Install the air cleaner with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Tighten the hose clamp.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the ventilation hose and vacuum hose.

  1. Connect the MAF meter connector and clamp.



4. INSTALL V-BANK COVER SUB-ASSEMBLY


    A214821E01
  1. Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.