Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here


NOTICE:
  1. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.
  2. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the intelligent tester or Techstream and write them down before removal.



1. REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



2. REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab, for CrewMax)
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH
  1. Remove the cowl side trim board RH .

    HINT:
    Use the same procedures described for the LH side.



4. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B226741
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



6. REMOVE TIRE PRESSURE WARNING ECU


    C153802
  1. Disconnect the ECU connector.

  1. Remove the 2 nuts and ECU.