CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the Techstream, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed is displayed | - |
| CCS Mem Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed stored in memory | - |
| Cruise Operation Status | Shift lever position signal / ON or OFF |
| - |
| Cruise Control | Cruise control / ON or OFF | ON: Cruise control is SET OFF: Cruise control is UNSET | - |
| CCS Indicator M-CPU | CRUISE main indicator light (Main CPU) / ON or OFF | ON: CRUISE main indicator light is ON OFF: CRUISE main indicator light is OFF | - |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / ON or OFF | ON ←→ OFF: Changes each time main switch is pushed | - |
| Main SW M-CPU | Cruise control main switch (Main CPU) / ON or OFF | ON: Cruise control main switch (Main CPU) is SET OFF: Cruise control main switch (Main CPU) is UNSET | - |
| Cancel Switch | CANCEL switch / ON or OFF | ON: CANCEL switch is SET OFF: CANCEL switch is UNSET | - |
| SET/COAST Switch | -/SET switch / ON or OFF | ON: -/SET switch is SET OFF: -/SET switch is UNSET | - |
| RES/ACC Switch | +/RES switch / ON or OFF | ON: +/RES switch is SET OFF: +/RES switch is UNSET | - |
| Stp Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Throttle Opening Angle | Cruise throttle opening angle / min.: 0°, max.: 124.5° | Actual demanded throttle angle | - |
| Brake Cancel Switch | Brake pedal cancel switch signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Distance Control* | Cruise cancel signal / ON or OFF | ON: Cruise control cancel OFF: cruise control operating | - |
| PERFORM ACTIVE TEST |
Warm up the engine.
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the Techstream, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | CRUISE main indicator light operation | OFF or ON | - |