Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    Remove the front seat (Click here).

  1. for Power Seat:
    Remove the front seat (Click here).



4. REMOVE FRONT DOOR SCUFF PLATE


B165841
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate.



5. REMOVE REAR DOOR SCUFF PLATE


B165842
  1. Detach the 6 claws and 2 clips, and remove the rear door scuff plate.



6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed .



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
  1. Partially remove the rear door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed .



8. REMOVE LOWER CENTER PILLAR GARNISH


B165827
  1. Detach the 2 claws and remove the cover.



    B165828
  1. Remove the bolt and seat belt anchor.



    B165829
  1. Detach the 7 clips and 2 claws, and remove the pillar garnish.



9. REMOVE CENTER PILLAR GARNISH
  1. Using a screwdriver, detach the 2 claws and remove the 2 assist grip plugs.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 bolts and assist grip.

  1. Remove the 2 screws.

  1. Detach the claw.



  1. Pass the front seat outer belt floor anchor through the center pillar garnish, and remove the center pillar garnish.


    B165825E03



10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


B166608
  1. Remove the nut and shoulder anchor.



    B166609
  1. Disconnect the pretensioner connector as shown in the illustration.



    B166610
  1. Remove the 2 bolts and seat belt.