Home › ENGINE ยท 1UR-FE › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY
  1. Install the flywheel housing side cover.

  1. Install the starter with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the starter wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.

  1. Attach the 2 wire harness clamps.



2. INSTALL STARTER COVER
  1. Install the starter cover with the 3 bolts.

    Torque:
    12 N*m{ 117 kgf*cm , 8 ft.*lbf }



3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL