THROTTLE BODY > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 4. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum sensing hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 5. REMOVE THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the 2 water by-pass hoses.
Disconnect the throttle position sensor and control motor connector.
![]() |
Remove the 4 bolts, throttle body and gasket.
![]() |
Remove the No. 12 water by-pass hose from the throttle body.
![]() |
Remove the No. 4 water by-pass hose from the throttle body.